Answer for viewing pulled streams

Hello, The fact that you can’t connect your web ui using something other than the loop back address is concerning. Perhaps we can simplify the "sanity check". If you install the "socat" command, you can try the following: socat -u UDP-RECV:1234,bind=239.1.1.100,ip-add-membership=239.1.1.100:0.0.0.0 CREATE:/tmp/out.ts This will receive all the UDP bytes from your multicast stream and put them into the /tmp/out.ts file. If you let this command run for a little while (maybe 10 seconds) you can then try to play the file (or just see if the file has any data in it). This will narrow down the problem to: Is it a networking problem, or is it a stream ingestion problem. I’d also want to see the logs (or see if the EMS is showing any errors). You can forward me the .log files, or you can run in console mode and just capture the console output. Bryan

Offcanvas

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua.